If your monitor is not listed, restart the monitor and connect within five minutes.
Older device or missing PIN?
Older firmware may appear as S9-Energy followed by letters or numbers. The original Bluetooth PIN is 123456; use your changed PIN if you set one. Restart the device to reopen setup.
Choose your home Wi-Fi and enter its password. Your device uses the 2.4 GHz network.
Finish with your email so this device is available on your other phones. We’ll reuse your sign-in when possible.
Monitor activation is missing
This monitor was not fully prepared for account access. Repeating Wi-Fi setup will not fix it.
Keep the monitor name below when contacting S9. No Wi-Fi password is needed.
If both addresses stop working, reconnect using Bluetooth during a setup window to refresh them. Restarting the monitor opens a five-minute setup window.
Connecting your device…
Connecting to your monitor.
Keep your usual Wi-Fi
Connect the monitor to your home network for everyday use.
Battery-saving recording
Connection times
In battery-saving mode: about 30 seconds to connect, every 5 minutes. Start Live View to stay connected for 5 minutes.
Connect once to see your next expected window. Timing may change after a restart.
Live View uses much more battery power.
Ready when you are
Connect your energy monitor
Use First-time setup to choose the correct Wi-Fi name and address for your monitor.
Battery
Estimated battery level
—
Waiting for a reading
Battery used today
— Wh
Checking average
Recorded on your monitor
Solar Power
☀
Solar power now
— W
Waiting for a reading
Energy collected today
— Wh
Checking average
Recorded on your monitor
Power history
SolarChargingIn use
Energy totals in Wh. Net battery = charged minus used.
Collecting your first readings.
Gaps mean no recorded reading
Tap the graph to see a reading.
Camera energy & battery savings
Battery savings from measured camera use
Measured camera use: 1.67 Wh/day at 5 V. From the earlier camera-only test.
—estimated AA battery equivalents
— est. camera battery changes (2 AA)— est. equivalent battery cost
Energizer Ultimate Lithium · Camera estimate unavailable: recorded battery time missing
Based on measured camera consumption
The 1.67 Wh/day camera figure comes from the owner’s earlier camera-only measurement at 5 V. The counter applies that measured daily rate to the monitor’s recorded battery measurement time: camera energy = 1.67 × recorded days. Monitor consumption is excluded.
Every 2 AA equivalents count as one battery change: calculated camera energy ÷ 10.2 Wh. Each AA uses a nominal 5.1 Wh reference from Energizer’s specifications. Fractions show progress through a pair’s worth of energy. Estimated value uses C$20 per pack of 8 (C$5 per pair).
Camera energy for this period, battery-change equivalents and cost are calculated from the measured daily consumption, assuming similar camera activity. Activity, temperature and usable AA capacity can change the result. Recording gaps are excluded; resetting battery measurement time resets this counter.
Measured Solar In and Battery In/Out remain in More readings & explanations. Battery Out includes monitor use and conversion losses, so it is not counted as camera-only savings. This counter does not assign a solar-versus-battery percentage to the camera.
More readings & explanations
Compare with earlier days
Recorded energy in watt-hours (Wh)
Period
Solar collected
Battery used
Yesterday
—
—
Last 7 days
—
—
Last 30 days
—
—
7 and 30 days include today. Gaps are left out. Battery used counts energy taken from the battery; charging does not subtract from it.
Battery comparison
Checking recorded history for the same hours on recent days.
Solar comparison
Checking recorded history for the same hours on recent days.
Voltage
—V
At this connection
Current
—A
— mA
Solar energy balance
—Wh
Since the last reset
Lifetime totals
Saved on your monitor
Solar In—Wh
— mAh
Average per day— Wh— mAh
Battery In—Wh
— mAh
Average per day— Wh— mAh
Battery Out—Wh
— mAh
Average per day— Wh— mAh
Recorded time—
Per 24 hours of recorded readings. Arrows compare Wh/day with the start of that day. Green: more energy in or less battery use. Red: less energy in or more battery use. Yellow: unchanged.
Totals are saved on your monitor.
Records save automatically every five minutes. Save before unplugging to keep the latest readings.
Solar In is energy collected from the panels. Battery In/Out measures charging and use at the battery. Each channel keeps its totals since its last reset.